People often wonder what is the best garbage disposal to get to avoid these problems. Without going into a full blown garbage disposal review, a good plan is to choose a model with the highest horsepower rating your budget allows. And make sure the model you select has a way to manually turn the shaft if it gets how to repair a garbage disposal stopped up.
It Makes A Difference How You Use It
No matter what kind of garbage disposal you have, how you use it has more to do with how well it works than what brand or model it is. Even the best garbage disposal clogs up sometimes, especially if it gets a lot of heavy use.
Remember To Always Turn The Faucet On First
So how should you use your garbage disposal? The first rule is to always turn the faucet on when you are using a garbage disposal and let it run for several seconds after you turn the disposal off. Remember, everything that you put in the garbage disposal goes right into your plumbing system so it takes a little water to wash it down the pipes.
Take It Easy
Another tip is that it is not a good idea to try to put too many large pieces of food through the disposal. I’ve seen garbage disposal clogs caused by someone trying to grind big pieces of carrots. All of the drain piping under the sink was full of grated carrot.
Asking For Problems
It is certainly tempting to just dump everything into the big hole in the sink and flip the switch, but that is asking for trouble. I actually know of one situation where a guy was dropping eggshells down his disposal. He must have eaten a lot of eggs because the crushed up shells coated the inside of his kitchen drain pipe and finally stopped it up entirely. The entire drain pipe wound up having to be replaced.
Put The Big Chunks Somewhere Else
Hopefully that story shows how important it is to be careful how you use your garbage disposal. Put bigger scraps and trimmings in either the trash or a compost pile and use the disposal for the small stuff that would otherwise get rinsed down the drain. Your drain pipes will be better for it.
Garbage Disposal Clogs
Sometimes even if you have followed all of these guidelines the garbage disposal clogs up anyway. No problem, it’s pretty simple to learn how to unclog a garbage disposal. There are just a couple of basic steps to follow.
Does The Motor Need To Be Reset?
First, find out if the motor is jammed. If you flip the switch and the disposal just hums, it is most likely locked up. If the power stays on to the disposal this usually results in the motor cutting off, so lots of garbage disposals have a reset button (usually on the bottom). Turn the switch off, wait a few seconds and push the reset button.
Find For The Wrench Hole
The next step is to unjam the disposal. Most garbage disposals have an opening in the bottom that allows you to insert an “Allen Wrench” into the bottom of the shaft and manually turn the shaft to free it up. Sometimes the wrench is included with the disposal. If not a standard “Allen” wrench will get the job done.
How To Unclog A Garbage Disposal With A Wrench
Make sure the power switch is off before going to the next step! If you’re not sure, or if you have an air switch, turn off the breaker serving the disposal. Turn the faucet on and stick the wrench into the bottom of the shaft. The opening for this should be in the middle of the bottom of the garbage disposal. Now turn the wrench back and forth a couple of times until you can turn the wrench all the way around freely.